COBY electronic CD player User Manual

Cx-cd487 name of parts, Specification, General

Advertising
background image

During play, press and hold FF (or REW ) button
continuously to fast forward (or fast reverse) the current
track.

During pause mode, press FF (or RAW )
button to play the next track (or previous track).

LCD screen will display " Er " if the unit
can not read CD track data.

(3)

PAUSE

Press POWER ON button to pause on/off alternately,
TIMER will flash.

(1)

STOP

Press POWER OFF ( )button to stop play , LCD
screen will display the last track number.

LISTEN TO DESIRED TRACK

Press FF (or REW ) button to set the desired
track#, press POWER ON ( )button to play. Press
FF (or REW ) button to change the track# during
the play mode.

(1)

Press FF button

When CD track data has been read, LCD SCREEN
will display the last track number with the total
play time.

(4)

Unit will start play from track No.1 automatically.

(5)

During play, press REW button to play
previous track.

(2)

Press MODE button twice to repeat all tracks.

(2)

Press MODE button three times during play
and "INTRO"will flash.

(1)

INTRO PLAY

Press POWER ON( ) button to start
INTRO play from track No.1

(2)

Press FF button to start INTRO
play from next tracks in random order.

(3)

Press REW button to start INTROplay from
current or previous track.

(4)

MOVE TO THE DESIRED SPOT

(1)

(3)

Press MODE button once to repeat one track.

(1)

REPEAT PLAY

Press MODE button four times at STOP mode
and "RANDOM" is displayed and flash.

(1)

RANDOM PLAY

Or

Press POWER ON( ) button to play tracks
in random order.

(2)

TO PROGRAM

(1)

PROGRAM PLAY

Press PROG. button at stop mode and
"PROG" and "00" will display.

(a)

Press FF (or REW ) button to select
the track number.

(b)

To cancel RANDOM mode, press MODE or
POWER OFF( ) button.

(3)

Press POWER ON( ) button to play
tracks in random order.

(2)

Select RANDOM mode during play and
"RANDOM" will flash.

(1)

When desired track is displayed, press PROG.
button to set.

(c)

Repeat (b)~(c) to set up to 24 tracks. The display will show the
current set track.

(d)

Set tracks can be checked by pressing PROG. button.

(e)

TO COMPLETE THE PROGRAMMING AND TO PLAY

(2)

Press POWER ON( ) button to start the
programmed tracks.

TO CLEAR THE PROGRAMMING, Press POWER
OFF( ) button.

(3)

Press ESP/BAND button to prevent disruption or
stopping of CD player. LCD will display
at anti-skip mode.

(1)" "is displayed when the battery voltage
reaches low.

(2)When the voltage is too low, the unit will
automatically turn off.

LCD screen will display band
and receiving frequency.

RADIO MODE

Slide RADIO/CD switch to RADIO position, press power on button
to turn the radio power on.

Band Selection

Press BAND button once to toggle the band
control from FM to AM.

Accessories Included ............Professional High Performance

Digital Neck Band Headphones

(Batteries not Included)

CD Play Section

Frequency Response..............................20 ~ 20,000Hz
Wow and Flutter......................................Below Measurable Limits
Sampling Rate.........................................8 times over sampling
D/A Converter..........................................1-Bit

General

Maximum Output (Stereo Headphone)....20mW+20mW(32ohm)

Power Supply

AC Adapter.......................................110V 60Hz (not included)
DC......................................................4.5V with DC Adapter

Dimension

................................

5.1"x 1.1"x 5.6"(WHD)

Weight

.................................

0.66lbs (Main Unit Only)

SPECIFICATION

COBY ELECTRONICS CORP.("COBY") warrants this product to the

original purchaser to be free from defects in material or workmanship

under normal use for 90 DAYS from the date of original purchase.

COBY agrees under this warranty, to repair or replace it with a new or

reconditioned product at no additional charge. Our warranty does not

cover any product which has been subjected to neglect, unreasonable

use, accident, violation of operating instruction or any product that has

been repaired or modified by an unauthorized service agent. To obtain

factory service, return this unit freight-prepaid to the address shown

below within the duration of this warranty. Enclose $6.00 for each item

in the form of money order made payable to COBY ELECTRONICS

CORP. to cover the cost of shipping and handing. Also, include a copy

of the sales receipt to show proof of purchase and a detailed description

of the problem. The unit(s) must be packaged in such a way as to rea-

sonably protect it from possible shipping damage. For further information

write to.

COBY'S liability under any legal theory for any loss damage in any way

related to this product shall not exceed the sales price of this product.

In no event shall COBY be liable for any incidental or consequential

damages resulting from the use of this product, or inability to use this

product. Repair or replacement as provided under this warranty is the

exclusive right of the consumer.

Except for the extent prohibited by law, no express or implied warranty

of merchant ability or fitness for a particular purpose on this product

shall be extended beyond the period of this warranty. Some States

prohibit the exclusion or limitation of incidental or consequential

damages, so that the above limitation or exclusion may not apply

to you. This warranty gives you specific rights, and you may also

have other rights which may vary from State to State.

90 DAYS LIMITED WARRANTY

COBY ELECTRONICS CORP.

Customer Service Dept.

56-65 Rust Street

Maspeth, N.Y. 11378

Press and hold TUNING/FF( ) or TUNING/REW( ) button for

about one second for fast setting.Fast setting rate: 8 steps per

second.

Once fast setting is proceeding onwards, release the key for auto

tuning.

Auto tuning stops when Station Detection signal is received.
When the tuning reaches the band edge, it wraps around to the

opposite end, and continues seeking onwards.

During auto tuning process, memory recalling or writing is not allowed.

Auto tuning can be stopped at once upon pressing TUNING/FF( ) or

TUNING/REW( ) button.

Memory Recall

Press PRESET button.

Memory number will be shown.

Memory number remains on each time when memory is recalled.

They will be blanked immediately when TUNING/FF or TUNING/REW

button is pressed to alter the existing frequency.

Memory Writing

Press PROG. key once to initiate memory writing process. Memory

set indicator "PROG " appears and flashes.

Press PRESET key once to enter the display frequency to the

desired memory, and press memory key again thus terminate the

writing process,Memory set indicator "PRESET" is shown frozen.

During the writing process. if no further valid key pressing is detected,

the microprocessor will terminate the writing process after 5 seconds

idling.The memory set indicator and memory number will be blanked.

If always adjusting the desired frequency prior to memory writing

process. It should be noted that once TUNING/FF or TUNING/REW

key is pressed, the memory writing process will be terminated and the

memory number will be blanked.

Other functions:

Stereo indicator: stereo indicator lights up on receiving FM stereo

signal from RF band.

Last AM and FM frequency and memory can be preserved if the time

of replacing the batteries and converting to CD mode not more than

30 seconds.

RADIO Section

FM.............................................................87.5- 108 MHz
AM.............................................................530 - 1720 kHz

ANTI-SKIP PLAY

Manual/Auto Tuning

Press TUNING/FF( ) or TUNING/REW( ) button to increase
or decrease the existing frequency by one step.
Upon reaching the band edge, it wraps around to the opposite
end.

When operating the unit with AC adapter

and non-rechargeable batteries in the

compartment, please make sure to set the

"Charge" switch to "Off" position to avoid

damaging the unit.

Ensure that all electrical connections(including the main
plug, extension leads and interconnections between
pieces of equipment) are properly made and in
accordance with the manufacture's instructions.
Consult your dealer if you are ever in doubt about the
installation, operation or safety of your equipment.

Read the instruction manual before operating this unit.
Do not expose the unit to high temperature or humidity.
Use dampened soft cloth to clean the unit. Do not use
strong detergent or solvent to clean the unit.

Insert the disc into the unit with the label of the disc
facing up.
Gently wipe the disc using a soft cloth from the center
to the outer direction to remove dust, fingerprints or any
other particles on the disc surface. Never use
chemicals, such as record sprays, anti-static sprays,
benzene or thinners to clean the CD. These chemicals
can damage the disc surface permanently.
To avoid serious scratches on CD, keep them in the
cases after each use. Scratches can cause the laser
pick-up skip in the future play.
Do not place stickers or write anything on the disc.

Please read and follow the instruction manual
carefully before operating in order to avoid any
damages to the unit. Any adjustment or repair
should be done by a qualified service center only
to receive warranty.

INTRODUCTION

Your unit operates on two(2) AA size alkaline batteries.
Open the CD cover and insert the batteries in the battery
compartment following the polarity diagram located
inside.

BATTERY OPERATION

(BATTERIES NOT INCLUDED)

RE-CHARGEABLE BATTERY OPERATION

(RE-CHARGEABLE BATTERIES NOT INCLUDED)

DBBS FUNCTION

The Dynamic Bass Boost System(DBBS) enhances the
low frequency(Bass) response of the output. Set the

3. Unplug the AC adapter after charging.

DO NOT CHARGE THE BATTERIES MORE THAN 24
HOURS OR MORE THAN RECOMMENDED TIME.
OVERCHARGING MAY DETERIORATE THE PERFORM-
ANCE OF THE RECHARGEABLE BATTERIES.

4. If the operating time decrease drastically after the
batteries have been recharged properly, purchase new
rechargeable NiCd batteries.
Do not attempt to recharge alkaline batteries. This may
cause leakage and damage to the unit.
Do not mix alkaline batteries with rechargeable batteries.

MONEY SAVING TIPS.

Due to the nature of CD technology, the unit uses power
even when the unit is off. To extend the batteries' life, use
the adapter for indoor operation or where power is
supplied. Use the battery operation only when the unit is in
mobile.

The CD mechanism and the sensitive circuitry may
cause interference to a radio tuner nearby. Do not
operate this unit while operating other radio devices.
Danger This product utilizes invisible laser
radiation. Avoid direct exposure
to the beam.
Caution Use of controls, adjustments or procedures
not listed in this manual may result

in

hazardous radiation exposure

.

CONCERNING COMPACT DISCS

IMPORTANT

Only compact discs identified with this
mark can be used with this player.

(2)

POWER ON

AUTO PLAY

CD MODE

Press POWER ON button to turn the power on.

(1)

LCD screen will display :

LCD screen will display " NO DISC", if CD is not in the
unit.

Slide the CD/RADIO switch to CD position.

Instruction Manual

SLIM PERSONAL CD PLAYER
AM/FM STEREO RADIO AND 45 SEC ANTI-SHOCK

CX-CD487

NAME OF PARTS

You can operate this unit with two "AA" rechargeable
batteries. For new or exhausted rechargeable batteries,
we recommend that (Refer to battery manufacturer's
guide)

1. Open the CD cover and insert the batteries (2x"AA") in
the battery compartment following the polarity diagram
located inside.

BOTH BATTERIES MUST BE RECHARGEABLE NiCd
TYPES. OTHER BATTERIES MAY EXPLODE OR LEAK.

2. Plug in AC adapter and slide the "CHARGE SWITCH"
to "ON" position to start charging.(AC adapter not included)

Volume to low listening level and press DBBS switch in
the direction of the arrow to turn this function ON.

Note: Some CD's with DBBS may exceed the bass
response capacity and can cause distortion. Do not play
DBBS in high volume. Playing DBBS in high volume may
cause damage to the headphone and more importantly to
your hearing.

HOLD FUNCTION

CAUTION

Hearing experts advise against the constant use of
personal stereo played at high volume. Constant high
volume use can lead to hearing loss. If you experience
ringing in the ears or hearing loss, discontinue use and
seek medical advice.

To remove the disc from its storage case, press down on
the center of the case and lift the disc out. Hold it carefully

This HOLD function prevents any unwanted function
changes during PLAY or STOP mode. Slide HOLD switch
to the arrow direction (or opposite) to turn the function
ON (OFF). No other function buttons operate on HOLD
mode, except DBBS function.(except radio function)

(1)

(AC adapter not included)

PLAY/POWER ON

botton

STOP/POWER OFF

button

DC jack

LCD Display

Hold switch(on

rear)

MODE button

Headphone jack

TUNING/REW

PROGRAM button

ESP/BAND button

CD/RADIO switch

DBBS switch

PRESETS

TUNING/FF

DOOR OPEN switch

Press REW button

Volume Control

Advertising