Workrite Sierra HX Electric Workcenters - Manual

1 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
1
Sierra HX Electric Workcenters
Special Settings
Change display from inches to centimeters
Simultaneously press and hold 1, 2 and Up
Arrow for 5 seconds until the display flashes
repeatedly.
Press the “SET” button with a ballpoint pen ( Do
NOT use a paperclip - it may damage the electronics )
to change from inches to centimeters.
To return to inches, repeat the same process.
a
b
a b
#1500170 Rev A
2
Set height memory positions / Raise or lower table to memory position
Raise or lower table to the desired height using Up or Down Arrow.
Press the “SET” button with a ballpoint pen ( Do NOT use a paperclip - it may damage the electronics ).
“S” will flash on screen 2 seconds.
While “S” is flashing, press 1, 2, or 3 to register height setting.
Screen will flash ‘S-1’, ‘S-2’, or ‘S-3’ twice to indicate the height setting has been recorded.
To move to preset height, press and hold 1, 2, or 3 until table stops at selected memory position.
a
b
or +
2 3 1
5
10
15
20
25 30 35
40
45
50
55 60
a b
c
d
c
or +
2 3 1
5
10
15
20
25 30 35
40
45
50
55 60
d
Up Arrow
Down Arrow
1 2 3
Memory
settings
SET
or +
2 3 1
5
10
15
20
25 30 35
40
45
50
55 60
or +
2 3 1
5
10
15
20
25 30 35
40
45
50
55 60