Workrite Willow Arm iPad Holder - Manual

#1500188 - Rev A
Important Safety Instructions
Use only a slightly damp cloth to clean the Willow Arm surface. Never use flammable solvents like alcohol, benzene,
thinner, etc. on the product.
Willow
TM
iPad Holder Installation Instructions
A
Willow-Poise Arm
iPad Holder
Qty: 1
Parts
B
#10 x 32 x ½
Phillips Screws
Qty: 4
Attach iPad Holder to Monitor Arm
1
Insert 4 screws (B) through the iPad Holder (A) and the
75 mm VESA plate of the Willow arm, securing each
screw with a Washer Nut (C).
C
#10 x 32
Keps Nuts
Qty: 4
2
Place the iPad into the bottom corners of
the iPad holder.
a
Adjust monitor arm balance
3
Once installation is complete it may be necessary to adjust the balance of the monitor arm. See
the instructions supplied with the monitor arm for directions.
Only gen 2
and 3 iPads
work with this
product.
Make sure the
iPad is fully
secured to
avoid dropping
the iPad.
To Detach iPad
4
To remove your iPad from the holder, use both hands and press firmly on the right and left top
corners of the holder to un-snap your iPad.
Push the top corners of the iPad until it
snaps into place.
b
a
b
Attach iPad
A
C
B