Cisco TOPSPIN SFS 3001 User Manual
Page 11
3
1. Take one connected pair of rack brackets and separate them. Each side arrives assembled to its
counterpart, but should be separated before attaching to the switch when using this method of
installation.
Figure 1-1: Assembled Rack Bracket Pair
2. Attach the rack bracket that has screw holes to the side of the chassis with the flange facing away
from the switch, as shown in
.
The standard method is to face the flange toward the front of the chassis. However, you can also
mount the flange toward the back if you want to mount the switch backward in the chassis
(service-side forward).
Figure 1-2: Attaching One Rail to Server Switch Chassis
3. Repeat
step 1
and
for the other side of the switch chassis.
NOTE: The two counterparts to these sliding rails (without screw holes) should still be
unattached.
4. Check your rack for clearance for the switch. The switch can be installed either directly on top of
another device (using the rubber feet, which are provided), or be suspended from the rack brackets.
Separate Brackets
Flange