Warning caution warning warning, Assembly step 4 – Chamberlain 1220E FS2 User Manual

Page 13

Advertising
background image

ASSEMBLY STEP 4

For Sectional and
One-Piece Doors Only

Install the Chain and Attach the
Sprocket Cover

INSTALLING THE CHAIN

1. Dispense a few inches of

chain from carton and
fasten to trolley with a
master link from the
hardware bag. (Figure 1).

• Push pins of master link bar through chain link

and hole in front end of trolley.

• Push master link cap over pins and past pin

notches.

• Slide clip-on spring over cap and onto pin

notches until both pins are securely locked in
place.

2. With the trolley against the screwdriver, dispense

the chain around the pulley.

3. Model 1210E:

• Continue along the rail and around the motor unit

sprocket (Figure 2). The sprocket teeth must
engage the chain. Continue forward to the trolley
threaded shaft.

Model 1220E:

• Continue along the rail and around the motor unit

sprocket (Figure 2). Proceed back around the
correct groove in the chain spreader (Figure 3).
The sprocket teeth must engage the chain.

4. Use the second master link to connect the chain to

the flat end of the shaft (Figure 1). Check to make
sure the chain is not twisted.

5. Remove the screwdriver.

ATTACHING THE SPROCKET COVER 1210E
ONLY

Insert the back tab in the slot on the back of the
mounting plate. Squeeze the cover slightly and insert
the front tab (Figure 4).

13

To avoid possible SERIOUS INJURY to fingers from
moving garage door opener:
• ALWAYS keep hand clear of sprocket while operating

opener.

• Securely attach sprocket cover BEFORE operating.

WARNING

CAUTION

WARNING

WARNING

Motor Unit
Sprocket

Install Chain
In This Direction

Chain
Spreader

Figure 2

Sprocket
Cover

Mounting
Plate

Front Tab Slot

Back Tab Slot

Top of Motor Unit

Figure 4

Master
Link Bar

Flat End
of Trolley

Trolley

Pin

Pin Notch

Flat End of
Threaded Shaft

Master Link
Clip-On Spring

Master
Link Cap

Install Chain
In This Direction

Chain
Pulley
Bracket

Figure 1

Leave Chain
& Cable
Inside Carton to
Prevent Kinking

Keep Chain
Taut When Dispensing

6-Tooth
Sprocket

Opener
Mounting Plate

Chain
Spreader

8-Tooth
Sprocket

Opener
Mounting Plate

Chain
Spreader

Figure 3

One-Piece Doors

6-Tooth Sprocket Application (Model 1220E)

Sectional Doors

8-Tooth Sprocket Application (Model 1220E)

(6-tooth sprocket can be used if slower travel speed

is desired.)

Advertising
This manual is related to the following products: