Assembly, Assembly step 1 – Chamberlain 1220E FS2 User Manual

Page 9

Advertising
background image

9

ASSEMBLY STEP 1

For Sectional and
One-Piece Doors ONLY
Assemble the T-Rail and
Attach the Chain Pulley Bracket

To avoid installation difficulties, do not run the
garage door opener until instructed to do so.

1. Place the 3 T-rail sections on a flat

surface for assembly. The end
sections are identical. The center
section must be positioned with the
braces against the end sections as
shown. Make sure the "directional
arrow" on the center section is
pointing toward the front (to door).
Study the illustration carefully.

2. Bolt rail sections together with the

hardware illustrated and from the
direction indicated. (When assembled,
T-rail has a front-to-back position as shown.)

NOTE: If T-rail is not assembled exactly as shown,
trolley will not travel smoothly along length of rail
or it will hit against nuts.

3. Position the chain pulley bracket on the front end

of the T-rail as shown. Fasten securely with the
hardware provided.

NOTE: When tightening the bolts be sure to keep
bracket parallel to the rail. Otherwise, the rail may
bow when the opener is operated.

Lock Nut
1/4"-20

Carriage Bolts
1/4"-20x1/2"

Hex Bolt
5/16"-18x7/8"

Nut
5/16"-18

Lock Washer
5/16"

HARDWARE

SHOWN ACTUAL SIZE

Rail
(Center Section)

1/4'' Lock Nut

RAIL FRONT
(TO DOOR)

Chain pulley bracket
attaches to FRONT
END of Rail

Rail
(End Section)

RAIL BACK
(TO OPENER)

Rail
(End Section)

Carriage Bolt
1/4"-20x1/2"

Brace

Brace

Square Carriage
Bolt Holes

TO G

ARAGE

DOO

R

Hex Bolts
5/16"-18x7/8"

Rail Bracket & Rail

Must Be Aligned

Lock Washer
5/16"

Nut
5/16"

Chain Pulley
Bracket

11 mm Socket Wrench

13 mm Socket Wrench

Advertising
This manual is related to the following products: