Industrial Injection LLY Dual CP3 User Manual

Industrial Injection For the car

Advertising
background image

Dual Fueler CP3 Pump Kit for LLY

Dual Fueler CP3 Pump Kit for LLY

8

Dual Fueler CP3 Pump Kit

Installation Guide for

LLY

Supplied Parts:

Rev: 07/06, v1.0

1. Control Module
2. 3/8” Inlet Fuel Line with Attached 1/2” x
1/2” x 3/8” ‘T’ Connector
3. 5/16” Return Fuel Line with Attached
5/16” x 5/16” x 5/16” ‘T’ Connector
4. High Pressure Steel Fuel Supply Line
5. two Idler Pullys with attached parts
6. Assembled CP3 Pump, Wheel, and
bracket
7. Fuel Rail Fitting
8. #6 Rib Belt
9. Oil Filler Tube

10. 2 #6 hose Clamps
11. 6 #4 hose Clamps (4 already on hoses)
12. 2 10x1.5x100 bolts with 2 washers
13. Control Module Internal Engine Pump
connectors
14. Control Module Dual Fueler Connector
15. Control Module +12V (Red Wire)
16. Control Module Ground (Black Wire)
17. Control Module Fuse 10A
18. Control Module Harness Tie Straps
19. Control Module Mounting Screws
20. two Fuel Supply Line Mounting Brackets

Please note these part numbers, they will be used in installation descriptions!

Appendix A: Troubleshooting

Engine noisy - Too Much Fuel Pressure

Cause: Check fuse is good and in controller’s fuse holder, and
all power connections are secure, including connectors for both
pumps are fully plugged in.

Appendix B: Fuel Pump with Bracket Assembly

3. Pully on pump by placing pully on
pump with, washer and nut, and torque
fuel injection pump drive pully nut to 52
lb ft.

1. Install Main Bracket and
insert 3 supplied bolts. Make
sure the

longer bolt L

and 2

shorter bolts S

are used as

shown.

L

S

2. Install

Smaller Support

Bracket

and secure with washer

and nut on the back of the pump
as shown. Secure other 2 bolts S
with washer and nut on the back
of the pump.

Smaller Support Bracket

drive pully nut

20

Industrial Injection

1201 S. 700W.

SLC, UT 84104

www.industrialinjection.com

Technical Support: 800-955-0476

Advertising