Metalfab SEW Eurodrive MOVIMOT MM..C - Manual (Page 76)

76
Operating Instructions – MOVIMOT® MM03C - MM3XC
7
Selectable special functions MM..C-503-00
Startup of Standard Design
Retrofitting the
brake rectifier If the brake rectifier BGM was not ordered as installed option, it must be retrofitted as
follows:
1. Exchange the brake coil (brake coil must correspond to the supply voltage).
2. Mount the brake control BGM with two screws according to the following figure (con-
nection according to wiring diagram on page 75).
3. Connect the external braking resistor according to the wiring diagram on page 75
(see the "Technical Data" section for assignment).
The installation is only allowed in conjunction with modular terminal box!
52122AXX
0 0
I