Cabletron Systems 7C03 - Manual (Page 17)

2-1
Chapter 2
Using the 7C0x SmartSwitch
Hub View
Navigating through the Hub View; monitoring hub performance; managing the hub
The heart of the SPECTRUM Portable Management Application (SPMA) for the
7C0x SmartSwitch is the Hub View, a graphical interface that gives you access to
many of the functions that provide control over the 7C0x hub and its installed
modules.
Using the Hub View
There are two ways to open the Hub View: if you are working within a network
management system, you can select the Hub View option from the icon menu;
specific directions for creating a 7C0x SmartSwitch icon and accessing the icon
menu can be found in the appropriate Installing and Using... guide. If you are
running the 7C0x SmartSwitch module in a stand-alone mode, type the following
at the command line:
spmarun fps <IP address> <community name>
The community name you use to start the module must have at least Read access;
for full management functionality, you should use a community name that
provides Read/Write or Superuser access. For more information on community
names, consult the appropriate Installing and Using... guide, and/or the
Community Names
chapter in the SPMA Tools Guide.