Ryobi AG453K - Manual

In addition to the items listed in the Packing List of the Angle
Grinder Operator’s Manual, this kit also includes:
n
Wire Wheel Brush: Suitable for removing paint or rust
from metal surfaces
n Abrasive Mop Disc: Suitable for sanding flat metal or
wood surfaces
n Case
WARNING :
To reduce the risk of injury, user must read and understand
the operator’s manual for the angle grinder before using
these accessories.
INSTALLING/RepLAcING WIRe WheeL oR
AbRASIve mop dISc
See Figures 1 - 2.
n Unplug the angle grinder.
n Depress and hold the spindle lock button and rotate nut
with provided wrench until spindle locks.
NoTe: To prevent damage to the spindle or spindle lock,
always allow motor to come to a complete stop before
engaging spindle lock.
n Loosen and remove flange nut from spindle. do not
remove disc flange.
n Make sure flats on the bottom of disc flange are engaged
with flats on spindle.
n Place the wire wheel or abrasive mop disc over the
spindle.
WARNING :
Always install abrasive mop disc with the depressed
center against the disc flange as shown. Failure to do so
will cause the disc to crack when tightening the nut. This
could result in serious personal injury because of loose
particles breaking off and being thrown from the angle
grinder. Do not overtighten.
n If installing wire wheel brush, thread the nut on the spindle
with the flat side of flange nut facing UP. Fit raised, small
diameter portion of the nut into the hole in the wheel and
finger tighten.
If installing abrasive mop disc, thread the flange nut on
the spindle with the flat side of nut facing DOWN. Finger
tighten.
n Depress and hold the spindle lock button and rotate the
wheel clockwise until the spindle locks in position.
n Securely tighten the flange nut with the wrench provided.
Do not overtighten.
Spindle lock
Flat(S)
Wrench
to
tighten
Flange nut
turned
correctlY
to
looSen
Wire
Wheel BruSh
nut turned
incorrectlY
diSc
Flange
aBraSiVe
Mop diSc
Spindle
Spindle lock
Flat(S)
Wrench
to
tighten
Flange nut
turned
correctlY
to
looSen
nut turned
incorrectlY
diSc
Flange
Spindle
Fig. 1 Fig. 2
opeRAToR’S mANUAL AddeNdUm
AG453K