Satellite Paperguard 3 Roll - Manual

PN 18142/REV D 6/15/11
INSTRUCTIONS PAPERGUARD 3 ROLL INSTALLATION
INTRODUCTION: Satellite portable restrooms and accessories must be assembled according to approved assembly procedures.
Variations in assembly could adversely affect product life and warranty.
HARDWARE:
TOOLS: *Drill, *1/4 Drill Bit, *#10 Drill Bit *Rivet Gun, *Block Wood, *Hammer
*NOTE: Check to see if Toilet has Handwash, Slimmate II, Swish or Fliptop tank. If so,
use location B.
Maxim 3000
®
1. Hold and level paperguard in location shown below. Transfer drill through (4) holes in paperguard with
a #10 (3/16”) drill bit into panel wall. Note: Be careful to drill through first layer ONLY.
2. Fasten with #18543 Peel Rivet (4).
Tufway
®
1. Hold and level paperguard in location shown below. Transfer drill through (4) holes in paperguard with
a#10 (3/16”) drill bit through panel wall.
2. Fasten with #10629 short rivet and #10047 push cap (push caps on the outside of the toilet) or
#11054 Rivet and #11315 Washer (Rivets on the outside of the toilet).