Satellite Slimmate 2 - Manual

PN 21206 REV A 9-28-11
INSTRUCTIONS FOR SLIMMATE II TM INSTALLATION
INTRODUCTION: Portable restrooms and accessories kits must be assembled according to approved assembly
procedures. Avoid variations in assembly procedures could adversely affect product life and warranty.
**CAUTION: The Slimmate II Handwash as well as any portable handwash unit should be cleaned and sanitized on a
regular basis. DO NOT DRINK THE WATER.
TOOLS: *Elect/Cordless Drill *1/4 Drill Bit *5/16 Drill Bit *1-1/8 Hole Saw/Drill Bit *Pencil *Adjustable Wrench
NOTE: Use #16364 Instruction, Slimmate II except for Figure #1 and #6. Use figure #1 and #6 from this
Instruction for the mounting of the Thal Mondo Slimmate II.
1.
Enlarge Hole: Using the 5/16 drill bit enlarge the 1/4 hole. (See figure #1)
2. Fastening Slimmate to Panel: Place Slimmate back in to the proper mounting location and fasten Slimmate to panel. (See
figure #6) NOTE: (It is very important that all hoses are in their appropriate relief channels.)
2530 Xenium Lane North, Minneapolis, MN 55441
Telephone: 763-553-1900 Fax: 763-553-1905
800-328-3332 web: www.satelliteindustries.com