Satellite Dispenser 4 Roll - Manual

19407 Rev.A, - 1 - 4/07
INSTALLATION INSTRUCTIONS FOR 4 ROLL VERTICAL PAPERGUARD
IN SATELLITE® TUFWAY, MAXIM 2000, MAXIM 3000 AND SYNERGY® HIGH
TECH 1, AND HIGH TECH II, AND TAURUS
TOOLS: ●Elec / cordless drill ●Rivet gun ●Drill bit # 10 ●Marker
Helpful hints:
*All paperguards on single wall units are fastened with the rivets being installed from the outside and the
washers on the inside of the toilet.
*Check to see if your toilet is getting a Handwash first, so you don’t drill holes in the wrong location.
*On the double wall toilets (High Tech and Maxim 3000) drill through the first layer only.
*Location of first mounting hole for toilets.
SINGLE WALL UNITS
Taurus
Fasten the 4 roll paperguard to panel using #11027 (3) Rivet, #66 alum and #11315 (3) Washer, 3/16 stnls.
Fasten paperguard on the inside with washer and rivet from the outside of the toilet. Using the top hole on
the inside of paperguard and Transfer drill bottom two holes (one on each side) through paperguard and
fasten to panel.
1. Mounting location without
slimmate. Mark inside right
panel near front. 3-3/4” down
from bottom of logo area and
4-1/4” over from molded
feature in panel. Then drill
hole using #10 drill bit 2. Mounting location with
slimmate. Mark inside right
panel near middle. 11” up
from bottom of logo area and
17-3/4” over from right edge
of logo area in panel. Then
drill hole using #10 drill bit. 3. Location without
slimmate 4. Location with slimmate