Satellite Tufway Accessory Location User Manual

Tufway unit accessory locations

Advertising
background image

#18382 Rev, A

1

7/06

TUFWAY UNIT ACCESSORY LOCATIONS

The following will be the standard locations for accessories when assembled by Satellite Industries

Location
“A”

PAPERGUARD
Right panel, see
Tufway unit assembly
instructions P/N
10900.

2 PAPERGUARD PER UNIT
Right panel, mount lower
paperguard see unit assembly
instructions P/N 10900. Mount
upper paperguard 2 ¼” directly
above lower paperguard.

3 ROLL PAPERGUARD Right
panel, see 3 roll paperguard
installation instructions P/N
18142

Location
“B”

PAPERGUARD WITH SLIMMATE II Left panel,
between vent pipe & rear panel in line with 4
dimples (same height). Measure 4-1/2” over towards
rear panel from top left dimple of four dimples in left
panel. Mark through top left hole in paperguard and
drill at mark using ¼” drill bit. Install rivet through top
left hole in paperguard into hole in panel & install
push cap and/or rivet from outside of panel. Mark 3
remaining holes (make sure paperguard hood is
level) in paperguard. Swing paperguard up out of
the way & drill at 3 marks in left panel. Install push
caps and/or rivets.

PAPERGUARDS /2 PER UNIT

WITH SLIMMATE II Mount lower
paperguard in the same location as
unit with Slimmate II with single
paperguard. Mount upper
paperguard 2” directly above lower
paperguard.

Location
“C”

PAPERGUARD/WITH
SLIMMATE II

Right panel, logo area

3 ROLL PAPERGUARD / WITH
SLIMMATE II
Right panel, see 3 roll paperguard
installation instructions P/N 18142


Advertising