Waterworks Universal Tile-in Shower Drain 6" x 6 User Manual

Installation guidelines

Advertising
background image


PRODUCT SUPPORT 800.927.2120 8am - 6pm EST

UNIVERSAL
Tile-in Shower Drain 6" x 6"

Installation Guidelines

Page 1 of 3

Rev - 01


7.14.2014

These guidelines have been prepared for the professional contractor to aid in the installation of:
UNIVERSAL TILE-IN SHOWER DRAIN 6" x 6" (STYLE No. UNSD06)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.

STYLE No. UNSD06


SPECIFICATIONS:

Outlet Connection: 2"
Outlet Connection Type: No Hub
Outlet Flow Rate: 10gpm

IMPORTANT:

To ensure this product is installed properly, you must

read and follow these guidelines.

The owner/user of this product must keep this

information for future reference.

This product must be on-site prior to rough-in. This

allows the installer to visualize the installation and
verify the center spread.

This product must be installed by a professional

licensed contractor.

Be sure your installation conforms to all federal, state,

and local codes.

In the State of Massachusetts, all installations must

comply with the rules and regulations set forth within
248 CMR.

Refer to the specification and assembly drawings

attached. Product is sold partially assembled but
shown fully disassembled for illustrative and service
purposes only.

Inspect the product to ensure you have all the parts

required for proper installation.

Use only a strap wrench or protected/smooth-jaw

wrench on any finished surface.

DO NOT use putty. Putty contains oil and can cause

permanent discoloration on certain materials such as
marble, granite and any porous surface.

INSTALLATION:

All images show a wood sub-floor installation.


For wood sub-floor installations:

 Install adequate blocking to properly support the

DRAIN BODY and strap the drain pipe.

 Cut a Ø6-1/4" hole in the sub-floor to properly

support the DRAIN BODY.

 The throat of the DRAIN BODY should pass through

the sub-floor and the flange of the DRAIN BODY
should rest on the sub-floor. See Figure – 01.

FIGURE -01

For concrete sub-floor installations:

 Backfill with dirt and concrete around the DRAIN

BODY.

1. Connect the DRAIN BODY to the pre-installed drain

pipe (not supplied). It may be necessary to trim the
drain pipe to obtain the proper final installation height.


2. Perform a leak test conforming to all federal, state,

and local codes.

3. Loosen the BOLTS and remove the CLAMPING

COLLAR from the DRAIN BODY. See Figure – 02.

4. Apply mortar or similar material over the sub-floor

pitched at a 1/4" per linear foot slope. The slope
should begin at the shower walls and end at the
DRAIN BODY. The mortar bed should be flush with the
top of the DRAIN BODY.

Do not apply mortar over the DRAIN BODY and take

care to keep the drain opening free of any debris.

SUB-FLOOR

DRAIN BODY

Ø6-1/4"

SUB-FLOOR

DRAIN BODY

Advertising