Waterworks Sentinel II Ceiling Mounted Round Lighting - Manual

Sentinel II
®
Sconce
1/08
WATERWORKS
Installation Guidelines
12 1 / 4 "
3 / 4 "
3 1 / 2 "
11 3 / 4 "
12 1 / 2 "
®
This product is sold partially assembled but shown fully
disassembled for illustrative and service purposes only.
®
for proper installation.
®
wrench on any finished surface.
®
INSTALLATION:
IMPORTANT: Light weighs 15 lbs. Junction box (7) NOT
provided must be secured to adequate blocking or stud
material.
1. Determine the orientation of the light and install either a
2" x 4" rectangular (wall mount) or 4" octagonal (ceiling
mount) junction box.
2. Run 120vac, 60hz electrical service to the junction box.
Install and Ground per NEC and local codes.
3. Unthread the 2 knurled fixture cover screws (1) and lift
off the fixture cover (2).
4. Connect fixture wires(6) to the house wires, note green
fixture wire is ground.
5. Secure fixture (4) to junction box using the following
junction box screws(3) NOT provided:
2" x 4" rectangular: 2 - #6-32
4" octagonal: 2 - #8-32
6. Verify the fixture is level before continuing.
7. Install (2) 7 watt max., E12 candelabra base ballasted
flourescent bulb; max length is approx. 4 1 / 2 " (5).
8. Reinstall fixture cover and hand-tighten the fixture cover
screws.
®
Support at 1-800-927-2120 (8am-7pm EST).
WWLT72
3
2
5 X2
6
7
4
1
IMPORTANT:
® To ensure this product is installed properly, you must read
and follow these guidelines.
® The owner/user of this product must keep this information
for future reference.
® WARNING: The power supply must be turned off prior
to installation.
®
These guidelines have been prepared for the professional contractor to aid in the installation of:
SENTINEL II SCONCE (WWLT72)
All dimensions are based on original specifications and are subject to change and variation.
Please consult your Design Associate for current specifications.