Canon IMAGERUNNER 2010F User Manual

Page 15

Advertising
background image

xiv

NOTE

Canon recommends an individual line following industry standards, i.e., 2500 (Touch
Tone) or 500 (Rotary/Pulse Dial) telephones. A dedicated extension off a PBX unit
without "Call Waiting" can be used with your facsimile unit. Key telephone systems are
not recommended because they send non-standard signals to individual telephones for
ringing, or send special codes that may cause a facsimile error.

C.Power Requirements

The machine should be connected to a standard 120 volt AC, three-wire grounded
outlet only. Do not connect this unit to an outlet or power line shared with other
appliances that cause "electrical noise." Air conditioners, electric typewriters,
copiers, and machines of this sort generate electrical noise that often interferes
with communications equipment and the sending and receiving of documents.

CONNECTION OF THE EQUIPMENT

This equipment complies with Part 68 of the FCC rules. On the rear panel of this
equipment is a label that contains, among other information, the FCC Registration
Number and Ringer Equivalence Number (REN) for this equipment. If requested,
this information should be given to the telephone company. (Note: REN is not
required for some types of analog or digital facilities.) This equipment cannot be
used on the public coin service provided by the telephone company. Connection to
party lines is subject to state tariffs. (Contact the state public utility commission,
public service commission or corporation commission for information.)

The REN is used to determine the number of devices that may be connected to the
telephone line. Excessive RENs on the telephone line may result in the devices not
ringing in response to an incoming call. In most, but not all areas, the sum of the
RENs should not exceed five (5.0). To be certain of the number of devices that may
be connected to the line as determined by the total amount of RENs, contact the
telephone company to determine the maximum RENs for the calling area.

An FCC compliant telephone line cable and modular plug is provided with this
equipment. This equipment is designed to be connected to the telephone network
or premises wiring using a compatible modular jack that is Part 68 compliant.

(Note: RENs are associated with loop-start and ground-start ports. Do not use for
E&M or digital ports.)

Even if the dual-line option is installed, the REN is applicable to each port. This
equipment if it uses an optional telephone receiver is hearing aid compatible.

Advertising