Canon IMAGERUNNER 2010F - Manual (Page 211)

Setting Up Your Machine as a Relay Unit 7-4
Rela
y Broadcasting
7
An asterisk ( * ) indicates the default setting.
NOTE
• To transmit the TX report to the originator fax machine, you need to set <SELECT ORIG
UNIT>.
• If you made a mistake when entering the file name, password, RX password, or
destination, use the cursor keys to go back to the position you want to correct
➞ press
(Delete)
➞ enter the correct value.
• To delete the entire entry, press (Clear).
03 TRIGGER
Sets up the ITU-T subaddress, sender’s fax
number, or e-mail address.
SUBADDRESS,
SENDER’S FAX
NO., or MAIL
ADDRESS
04 RX PASSWORD
Sets up the ITU-T password of the relay box. This
setting is optional. However, if you set an ITU-T
password for your relay box, the sending party
must enter the correct password to send
documents to your relay box.
Up to 20 letters
and numbers
05 SELECT ORIG
UNIT
If your machine is the relay unit, this feature forces
your machine to check the identity of the
originator before it receives the document, and
relays it to other units.
ON*, OFF
06 PRINT RX DOC.
If your machine is the relay unit, this setting
determines if your machine prints a copy of every
document that it relays.
OFF*, ON
07 SELECT
LOCATIONS
This item enables you to select the fax machines
to receive the document your machine relays. The
number of fax machines to receive the document
must be registered for one-touch or coded speed
dialing. You cannot enter a number with regular
dialing.
One-touch or
coded speed
dialing, or group
dialing
08 TX REPORT
This feature determines if your machine returns a
relay transmission report to the originator after
your machine receives and relays a document. NOT
TRANSMIT,
TRANSMIT*
09 TX START TIME
You can set your machine to hold documents, and
then relay them at a preset time. If you do not set
this item, all documents received for relay are
relayed immediately.
Up to five times
to relay
documents
within a 24-hour
period everyday.
10 RELAY B'CAST
This feature switches relay broadcasting ‘ON’ and
‘OFF’ without altering any of the other settings.
ON*, OFF
Item Description Setting