BendixKing KLN 89B - Pilots Guide - Manual (Page 189)

SID and STAR procedures are defined in three parts. The parts are
the SID or STAR name (e.g., PORTE9), a transition (e.g., Fellows),
and a runway specific component (e.g., RW 01L). The APT 7 pages
lead you through the selection process.
5.2.1. SELECTING A SID
Use the following procedure to select a SID. Some steps may not be
necessary depending on the procedure that you wish to fly. For this
example, the PORTE NINE departure from San Francisco
International (KSFO) will be used.
To select a SID:
1. Select KSFO on one of the airport
pages (figure 5-31). If you are
operating from an active flight
plan you can use the ACT 7 page
for KSFO by scanning through
the active flight plan (see section
4.2.3).
2. If not already displayed, rotate the
right inner knob until the APT 7
page appears as in figure 5-32.
Make sure that “SID” is displayed
in the upper right corner of the
display. This will allow the selec-
tion of SID procedures.
3. Turn the cursor on by pressing
B , and rotate the right outer
knob until the flashing cursor is
over PORTE9 (figure 5-33). With
the cursor over PORTE9, press
F
.
4. The KLN 89B will now ask which
runway that you will be using.
For this example select RW01B
(figure 5-34) and press
F
. The
“B” stands for “Both” so selecting
RW01B means it is applicable to
runways 1L and 1R.
Approaches and SID/STARs
5-30
Approaches and SID/STARs
Chapter 5
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm| KSFO 10ft
ееееее|SAN FRAN INTL
Leg|SAN FRANCISCO
APT 1 |CA
Figure 5-31
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm| KSFO SID
ееееее| 1 CUIT1
Leg| 2 DUMB5
APT 7 |10 STINS6
Figure 5-32
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm| KSFO SID
ееееее| 5 OFFSH2
# Leg| 6 PORTE9
*CRSR*|10 STINS6
Figure 5-33
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm|PORTE9-SID KSFO
ееееее| Runway 1 RW01B
# Leg| 2 RW10B
*CRSR*| 4 RW28B
Figure 5-34