BendixKing KLN 89B - Pilots Guide - Manual (Page 57)

Basic GPS Operation
3-20
Basic GPS Operation
Chapter 3
3. Once you have entered the
complete identifier, press
F .
The display will change to the
waypoint page for the waypoint
you entered (figure 3-65).
4. If this is the waypoint you intended
to enter, press F again. The display will change back to the
SET 1 page.
NOTE: As an alternative, you can also enter the approximate latitude
and longitude of your present position directly on the SET 1 page
instead of entering a waypoint.
5. With the right inner knob, position
the cursor over Ok?, if it is not
already there (figure 3-66).
6. Press F to approve the initial
position. The cursor will
automatically be removed from the
screen.
NOTE: If the KLN 89(B) is in the
Take-Home mode, you are allowed to
enter the groundspeed (kt) and head-
ing (°) fields in order to simulate flight
(figure 3-67). They are not used for
actual initialization in an aircraft.
However, entering a ground speed will
allow the KLN 89(B) to “fly” along the active flight plan (or to a direct to
waypoint) starting from the initialization waypoint. A heading may be
entered in the initial heading field while in the Take-Home mode if the
one offered is not desired. See section 4.11 for more details on the
Take-Home mode.
7. Select the NAV 2 page. When the KLN 89(B) reaches the NAV
ready status and is therefore able to navigate, the NAV 2 page will
display the present position. Verify that the latitude and longitude or
the waypoint, radial, and distance display of present position are
correct.
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm|INIT POS:CYYC
ееееее| N 51°06.83'
Leg| W114°01.22'
SET 1 |200kt 43°
Figure 3-67
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm|INIT POS:CYYC
ееееее| N 51°06.83'
# Leg| W114°01.22'
*CRSR*| Ok?
Figure 3-66
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm| CYYC 3560ft
ееееее|CALGARY INTL
# Leg|CALGARY
APT 1 |AB
Figure 3-65