BendixKing KLN 89B - Pilots Guide - Manual (Page 71)

Basic GPS Operation
3-34
Basic GPS Operation
Chapter 3
5. Use right outer and inner knobs
as in the previous steps until the
desired identifier is completely
displayed (figure 3-104).
6. Press
F
to display the waypoint
page for the selected waypoint
(figure 3-105).
7. Press
F
again to approve the
displayed waypoint page. The
screen will change to the NAV 1
page, and the selected waypoint
will now be the active Direct To
waypoint (figure 3-106).
‡NOTE: In some cases during
approach operations, the KLN 89B
presents a page asking how a way-
point is used when the waypoint
identifier is entered character by char-
acter. When this page is presented, simply choose the desired use of
the waypoint (e.g. FAF or MAHP) by moving the cursor with the right
outer knob and pressing
F
. Choosing the correct use of the way-
point is required to ensure proper waypoint sequencing once the
aircraft reaches the waypoint.
To fly Direct To a waypoint (procedure 2):
1. Select the desired waypoint page
(APT, VOR, NDB, INT, or SUP)
on the screen (figure 3-107) using
one of the three procedures
explained in section 3.7.
2. Press
D
. The Direct To page is
displayed and it contains the
desired waypoint identifier
(figure 3-108).
3. Press
F
. The display will revert
to the NAV 1 page with the
selected waypoint as the Direct
To waypoint.
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm| JJC 396
ееееее|MOUNTAIN CITY«
Leg| N 36°24.99'«
*CRSR*| W 81°49.46'
Figure 3-107
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm| DIRECT TO:
ееееее|«
# Leg| JJC ««
*CRSR*|
Figure 3-108
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm| KCAD 1310ft
ееееее|WEXFORD CO«
# Leg|CADILLAC«
APT 1 |MI
Figure 3-105
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
óñ.ònm| ∂∆ KCAD
121kt|> ªªªª∑ºπªªªª
Leg|DTK 167° TK 168°
NAV 1 |>167°To 0:41
Figure 3-106
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm| DIRECT TO:
ееееее|«
# Leg| KCAD «
*CRSR*|
Figure 3-104