Panasonic SA-AX6 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

I

3

£

BQ

75 £1 coaxial
cable
(not included)

Antenna plug

{included)

FM outdoor antenna
(not included)

300 Q feeder wire (not included) |

f 1 'i

20 mm

10 mm

i

(Z)

I (D

Lead wire

Plastic bar L

Press down with pliers.

This antenna is normally sufficient for reception of FM broadcasts.

Attach to a wall (using tape) facing in the direction of best reception.

For best reception
An FM outdoor antenna is recommended.

An outdoor antenna should be used when using this unit in moun­

tainous areas or in spaces enclosed by reinforced concrete where
the FM indoor antenna (included) does not provide satisfactory

reception.
Disconnect the FM indoor antenna if an FM outdoor antenna is
installed.

An^fina connecf/ons

An outdoor antenna should be installed by a qualified technician
only.

How to use the antenna plug (included)

Two types of wire are most commonly used for connection from the

antenna: 300 £2 parallel feeder wire or 75 £2 coaxial cable. For best
resistance to outside interference, the use of 75 £2 coaxial cable is
suggested.

M To connect a 75 U coaxial cable

(T.) Remove a piece of the outer vinyl insulator.
(|) Remove the cover while pulling the tabs.

If the tabs are pulled too hard, the casing may be damaged,

(3 ) Remove the lead wire and clamp it with the plastic bar.
(4) Install the coaxial cable.

Clamp the cable conductor, and wind it on so that it doesn’t
contact anything else.
Attach the cover.

9 To connect a 3Q0 O. feeder wire M

Loosen the screw to connect the feeder wire and tighten it to secure

the connection.

300 £2 feeder wire

(not included)

Advertising