Panasonic SA-AX6 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

This antenna is normally sufficient for reception of AM broadcasts.

Fit the AM loop antenna holder (included) onto the rear panel of this
unit and then attach the AM loop antenna to the AM loop antenna
holder (facing in the direction of best reception).

Pay attention to the following points when mounting the antenna.

e Do not mount it close to power cords, speaker wires or metal sur­

faces (Doing so will result in noise),

e Do not mount it dose to a tape deck. When the tape deck is being

used, chirping or beeping sounds may result.

Antenna connections

When mounting the antenna to a column,

q

wall or rack

Mount the antenna so that the hinge is vertical.

£

Q>

QQ

m

Screw (included)

E

Vinyl-covered wire

(not included)

An outdoor antenna should be used when using this unit in moun­

tainous areas or in spaces enclosed by reinforced concrete where
the AM loop antenna (included) does not provide satisfactory recep­
tion.

Stretch 5 to 12 m of vinyl-covered wire horizontally across a window
frame or other convenient location, keeping it as high as possible
from the ground.

When the unit is not in use, disconnect the outdoor antenna to pre­
vent possible damage that may be caused by lightning. Never use
an outdoor antenna during an electrical storm.

Be sure to connect the AM loop antenna even when AM outdoor
antenna is used.

Advertising