Panasonic SA-AX6 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

I

<u

wi

s

1

polarities (®, ©).

Concerning fhe remote control

mm

o Thoroughly clean the battery compartment before inserting new

batteries.

® Do not mix o!d and new batteries, or batteries of different types

(carbon and alkaline, etc.).

® If you will not use the remote control for a long period of time,

remove the batteries and store them in a cool, dark place.

® Do not use rechargeable type batteries.
© Do not attempt to recharge alkaline or carbon batteries.
9 Always remove old, weak or worn-out batteries promptly and dis­

pose of them properly.

9 Never subject batteries to excessive heat or flame; do not attempt

to disassemble them; and be sure they are not short-circuited.

® If the leaking electrolyte comes into contact with skin or clothes,

flush with water immediately.

When you need to replace these batteries

Use two R6/LR6, AA, UM-3 batteries.

Remote control signal sensor

^0 ooa ó(^ ( 1

o

Ok OGQOOCO

SO® 00000=5

1 1

o o o o ©

Transmission

window

oooo

oooo

‘o CD O

o Q o

oao

o O o

oo o

Avoid any obstacles

About 7 meters in front
of the signal sensor.

(The actual range will
depend on the angle at

which the remote control

is used.)

m

Be sure the transmission window and the signal sensor are free

from dust. Excessive dust might effect performance.

The operation may not be correct if direct sunlight or other strong

tight source strikes the signal sensor of this unit. If there is a prob­
lem, place the unit away from the light source.

Advertising