Panasonic KX-F750 - Manual (Page 68)

Troubleshooting and Maintenance
Troubleshooting
Error messages on the display
If the unit detects a problem, one of the following messages will appear on the display.
ERROR MESSAGE CAUSE AND REMEDY
BATTERY LOW
• Battery power is low. Replace the batteries with new ones (see
page 10).
CHECK COVER
►The top cover is open. Close it.
CHECK DOCUMENT
CHECK MEMORY
•The document is not fed into the unit properly. Re-insert the document.
If the misfeeding occurs frequently, clean the document feeder rollers
inside the unit (see page 73). Still it remains unsolved, adjust the
feeder pressure (see page 72).
• Memory (phone numbers, parameters, etc.) has been erased.
Re-program them.
MECHA ERROR
'Mechanical error occurred. Open the cover and re-install the recording
paper. Then press the STOP button and close the cover.
MEMORY FULL
NO ANS GREETING
►There is no room left in memory to record a message. Erase some or
all messages (see page 29).
►The greeting message for the ANS/FAX mode has not been recorded.
Record the greeting message (see page 13).
NO RESPONSE
►The receiving unit is busy or out of recording paper. Try again.
NO TEL GREETING
►The greeting message for the TEL7FAX mode has not been recorded.
Record the greeting message (see page 13).
OUT OF PAPER
►The unit ran out of recording paper. Replace it with a new one (see
page 9).
PAPER JAMMED
•The recording paper is jammed. Clear the jammed paper (see
page 71).
POLLING ERROR
•The other unit does not provide the polling function. Check the other
party.
REMOVE DOCUMENT
•The document is jammed. Open the cover, remove the jammed
document (see page 72) and try again.
•Attempted to transmit a document longer than 600 mm (235/&"). Press
the STOP button and remove the document (see page 72).
When sending such a document, divide it into two or more sheets so
that each sheet does not exceed 600 mm {23W) and try again.
68