Panasonic WV-CPR650 - Manual (Page 40)

This menu lets you adjust and set up the video signal
of the camera to meet your requirements.
Move the cursor to RET on the bottom line of the CAM
SET UP menu and press ^ or simultaneously for
2 seconds or longer. The SPECIAL menu appears on
the monitor as shown below.
10. special Menu (SPECIAL)
•* CAM SET UP
CAMERA ID 07F n
AU:/B1.C ALC
SHUTTER —
AQC ON
SENS UP OFF
SYNC INT
WHITE BAD ATW “1
MOTION DBT OFF
LENS DRIVE DC
/----------------
** SPECIAL •*
--- ^
UP SIDE DOWN OFF
CHROMA GAIN
AP GAIN
PEDESTAL . I.
HUE .1.
-
CAMERA RESET ^ PUSH SW
^RET END
J
10-1. Camera Picture Upside Down Positioning
(UP SIDE DOWN)
1. Move the cursor to the UP SIDE DOWN parameter.
2. Select ON when you want to turn the picture
upside down.
1. Move the cursor to the CHROMA GAIN parameter.
2. While observing the vectorscope or color video
monitor, move the ‘T’ cursor to adjust the chroma
level.
10-3. Aperture Gain Setting (AP GAIN)
1. Move the cursor to the AP GAIN parameter.
2, While observing the vectorscope or video monitor,
move the T cursor to adjust the aperture gain
level.
10-4. Pedestal Level.Setting (PEDESTAL)
1. Move the cursor to the PEDESTAL parameter.
2. While observing the waveform monitor/oscillo-
scope or video monitor, move the "I” cursor to
adjust the pedestal level (black level).
10-5. Chroma Phase (Hue) Setting (HUE)
1. Move the cursor to the HUE parameter.
2. While observing the vectorscope or color video
monitor, move the “I" cursor to adjust the hue
(chroma phase) level.
10-2. Chroma Level Setting (CHROMA GAIN)
-38-