Panasonic KX-TG2670N - Manual (Page 65)

Setting the Remote Code
The remote code prevents unauthorized people from accessing your unit
and listening to your messages. Choose any
2-digtt number (00-99).
The factory preset remote code is “11”. If you do not program your own
remote code, you can use “11”.
Use the handset near the base unit. Make sure the unit is in the
standby mode initially.
1
8
Press
[FUNCTION/^.
Press ® or ® repeatedly until the arrow
points to “Program”.
Press ®
{ ygs
key).
Press ® or ® repeatedly until the arrow
points to “TAD program”.
Press ® (Yes key).
•The base unit display shows programming
options.
Press (T).
•The current remote code is dispiayed on the
base unit.
Enter a remote code using a 2-digit
number (00-99).
Press ® (Save key).
•A beep sounds.
•To return to the standby mode, press [OFF].
►Program
Calling pager
TA ►=Yes
►Save DIRECT#
Set flash time
T i ►=Yes
Set dial mode
►TAD program
T A ►=Yes
Answering
system setting.
See base unit.
Base unit display
•If 6 beeps sound during programming, a wrong key was pressed. Enter the
correct number.
To check the remote code
Repeat steps 1 to 6.
•The current remote code is dispiayed on the base unit. When finished, press
65