Panasonic KX-TG2670N - Manual (Page 83)

Problem Remedy
The unit does not display the
caller’s name and/or phone
number.
•You need to subscribe to a Caller ID
service from a telephone company.
•Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
•Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
•Telephone line noise may be affecting
the Caller ID information.
The handset or base unit
display goes to the standby
mode while viewing the
Caller List.
•Do not pause for over 60 seconds while
searching.
or 1 DIGITAL SP-PHONEl.
was pressed.
When a second call is
received during a
conversation, the unit does
not display the new caller’s
name and/or phone number.
•The line mode selection is incorrect. See
page 14.
You cannot page the
handset or the base unit.
•The handset is too far from the base unit.
•The handset or the base unit is engaged
in an outside call, viewing the Caller
List/directory list or listening to
messages. Try again later. If you are
using the base unit, wait until “Handset
in use” disappears.
You cannot redial by
pressing IREDIAUPAUSE) or
(REDIALI.
•If the last number dialed was more than
32 digits long, the number will not be
redialed correctly.
•Access numbers entered after pressing
iTONEl will not be included when
redialing.
•The iREDIAL/PAUSEl button on the
handset has a double function as either
redial or pause. It will redial the last
number dialed if pressed at the outset of
a call (p. 27). If another number has
been dialed first, it will operate as a
pause button (p. 52).
83