Moving the unit, Using the wheels to move the unit, Lifting the unit – Panasonic EP3203 User Manual

Page 30: Caution, Pipe and plastic areas, Seat fabric, Cleaning and maintenance

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CLEANING AND MAINTENANCE

Moving the Unit

Using the Wheels to Move the Unit

* Please lift up the front of the unit when moving it by holding the pipe section on

either side of the legrest.

* Please be careful because the unit is heavy.

* It is easier to move the unit with the massage heads retracted and the backrest

in the upright position.

* Place a mat on the floor and gently roll the unit over it to avoid damaging the floor.
* Do not move the unit while someone is seated on it.
* Please remove the control panel from the control panel stand.
* Please make sure the legrest slider is fully retracted when moving the unit.

Lifting the Unit

* Move the chair by having one person hold onto the pipe sections on either side

of the legrest and another person use the handles on the back.

* Please hold the handles and legrest securely to avoid dropping the unit as it

may damage your floor.

* Please make sure the legrest slider is fully retracted when moving the unit.

CAUTION

• Do not move the unit while someone is seated on it.
• When moving the unit using the wheels, remove ali obstacies

from around it, make sure the backrest is in the upright position,

iift it no higher than waist height (no higher than 32 in. (80 cm))

and roli it slowly.

Failure to do so may cause the unit to tip over, which may lead to damage
or injury.

V_____________________________________________________________ J

Synthetic Leather on the Pillow, Back
Cushion and Armrests

• Wipe these areas with a soft, dry cloth. (Do NOT use

cloths containing any kind of chemical, etc.)

• If the synthetic leather is particularly dirty, soak a soft

cloth in water or a 3~5% solution of mild detergent,
wring it out thoroughly and tap the surface with it. Next,
rinse the cloth in water, wring it out thoroughly and then
wipe any remaining detergent from the surface, wipe the
surfaces with a soft dry cloth and allow them to dry

naturally.
(Do NOT use a hair dryer to try to dry the surfaces more

quickly.)

Mild

Detergent

■ Do not allow the unit to be in contact with these areas

for extended periods of time as this may lead to
discoloration.

CAUTION

Always unplug the unit before cleaning it. Never

touch a power plug with wet hands.

Failure to follow these instructions may lead to
electrocution or burns.

Pipe and Plastic Areas

(1) Wipe the unit with a cloth that

has been soaked in a mild
detergent and then

thoroughly wrung out.

(2) Next wipe the unit with a cloth

that has been moistened with
just water and thoroughly
wrung out.

* Make sure you thoroughly

wring out the cloth first when
cleaning the control panel.

(3) Allow the unit to dry naturally.

• Please do NOT use

thinners, benzene or alcohol.

Seat Fabric

(1) Wipe the seat fabric with a

cloth that has been soaked in
a mild detergent and then
thoroughly wrung out.

(2) Use a mild detergent and

brush on areas where the
seat fabric has become
particularly soiled. Be careful
not to brush the fabric too
much as you may damage it.

(3) Next wipe the fabric with a

cloth that has been moistened with just water and
thoroughly wrung out.

(4) Allow the fabric to dry naturally.

28

Advertising