Panasonic CF-47 Series - Manual (Page 26)

Reinstalling Software
Before Reinstallation
Preparing
You will need the Product Recovery CD-ROM included in the Windows System Pack and the FIRSTAID FD you made earlier.
X note )-
If you have not created the FIRSTAID FD, you can create by selecting [Create BACKUP DISK] in [Start] - [Pro­
grams] - [Panasonic]. If you can not create this disk, please contact Panasonic Technical Support.
________ ^^______________________________________________________________________________________ y
Important
• Save all important data. If reinstallation is carried out, all data existing prior to the installation will be lost. The
reinstallation will return the computer to close to the conditions at time of purchase.
• Before the reinstallation procedure, remove ail peripherals.
• Be sure the AC adapter is connected until the reinstallation procedure is completed.
Reinstalling
r'^_________
! If data on your hard disk is compressed, the data should >
\^e uncompressed.
^
1 Turn the computer on.
2 When the message [Press <F2> to enter SETUP] is dis­
played, press C and then run the Setup Utility.
If the password has been set, enter the supervisor pass­
word. ____
3 Press C e D
At the confirmation message, select [Yes] and press
C Enter ).
4 Select [Security] menu and set [Boot Up Drive] to
[CDD/A:/C:].
5 Set the Product Recovery CD-ROM and FIRSTAID FD.
6 Press (SD
At the confirmation message, select [Yes] and press
[ Enter ]. The computer will reboot, and this screen
should appear.
Select the number
1. Restore the whole HDD to factory default
2. Restore the drive C to factory default
3. End
Make a selection from the menu.
To restore all contents of the hard disk to factory
default, including the partition setting(s):
Select [1. Restore the whole HDD to factory default).
To restore the hard disk (C drive) to factory default,
excluding the partition setting(s):
Select [2. Restore the drive C to factory default].
X note >
I
FAT 16 fill FATI 6 file system is not supported.
At the confirmation message , press Œ).
The operations of “formaC and “restore’' for the hard disk
start automatically. (The operations take about one hour.)
After the reinstallation procedure completes, the following
message will appear on the display.
All data on the whole HDD has been restored to the factory default.
After removing floppy disk and the Product Recovery CD-ROM, restart the
computer and set up Window.s.....
Restart the computer by pressing (ctrD+CM3+CDiD,
and perform the setup procedure for Windows by following
the instructions on the screen. Q“ page 10
^ note >
During the reinstallation procedure, the settings of the
Setup Utility are changed as follows.
When necessary, please change these settings again.
Power Menu Power Management : Disable
Sleep Switch :No Action
When necessary, in the Setup Utility, set [Boot Up
Drive] to [A;/C:].
26