Converting an in-use phone from sccp to sip, Converting an in-use phone from sip to sccp, Deploying a phone in an sccp and sip environment – Cisco OL-8148-01 User Manual
Page 17
2-17
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
OL-8148-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Using Cisco Unified IP Phones with Different Protocols
See the “Configuring Startup Network Settings” section on page 3-14.
Step 3
Power cycle the phone.
Converting an In-Use Phone from SCCP to SIP
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use
in your network from SCCP to SIP. To access BAT from Cisco Unified
CallManager Administration, choose Bulk Administration > Phones > Migrate
Phones > SCCP to SIP. For detailed information, refer to Cisco Unified
CallManager Bulk Administration Guide.
Converting an In-Use Phone from SIP to SCCP
To convert a phone that is in use in your network from SIP to SCCP, perform these
steps. For more information, Cisco Unified CallManager Administration Guide.
Procedure
Step 1
In Cisco Unified CallManager Administration, delete the existing SIP phone from
the Cisco Unified CallManager database.
Step 2
In Cisco Unified CallManager Administration, create the phone as an SCCP
phone.
Step 3
Power cycle the phone.
Deploying a Phone in an SCCP and SIP Environment
To deploy Cisco Unified IP Phones in an environment that includes SCCP and SIP
and in which the Cisco Unified CallManager Auto-Registration parameter is
SCCP, perform these general steps:
1.
Set the Cisco Unified CallManager auto_registration_protocol parameter to
SCCP.