Panasonic NE-1757 - Manual (Page 16)

Installation Instructions for Stacking
Important
1. Disconnect the power cord from the wall receptacle
before attempting installation.
2. For stacking installation, you must use the
PANASONIC “Joint Plate” which is enclosed with
this unit.
3. Combination of the unit for stacking is limited within
only the following PANASONIC models.
NE-1257, NE-1757
4. The maximum stacking height is two units.
Preparation
Be sure the oven cavity is empty.
Installation
1. Stack the units and remove the screws from
individual unit as shown in Fig. 1.
2. Two projections on the joint plate must face away
from the oven.
3. Attach PANASONIC Joint Plate to top of the base
unit first by using the on the base 3 screws
previously removed. See Fig. 2.
4. Carefully place the top unit on the base so as to
align the five screw holes of the top unit with those
of the Joint Plate. Then attach and tighten five
screws. See Fig. 3.
Fig. 1.
Sanitary Counter Top Seal
When this microwave oven units are stacked on a
counter top, their base must be sealed in accordance
with N.S.F. Standards as per the following instructions.
1. Microwave oven should be located on a level
counter top surface. Complete the electrical,
connections.
2. Thoroughly clean the microwave oven bottom
perimeter and the counter top area around the
microwave oven perimeter.
3. Lay a generous bead of silicone seal around the
entire perimeter of the two microwave oven bottom.
4. Smooth the silicone seal into the crevice with finger
or tool to provide a cove seal.
Note: Remove the Air Filter from the front of the oven
before applying silicons.
DO NOT FORGET to re-install the Air Filter after
applying silicons.
- 16 -