Precautions for installation, How to install, Precautions for installation how to install – Panasonic AW-PH650 User Manual
Page 6: Mounting (pan/tilthead)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Mounting (Pan/tilthead)
■Precautions for installation
• Do not install this unit by suspending it, and do not install
it on its side.
• Using the four pan/tilt head mounting holes, fasten the
unit seourely with bolts whioh are long enough.
The mounting holes have a diameter of 10 mm. Use
suffioiently long bolts with an 8 mm diameter. Do not use
bolts with a diameter smaller than 8 mm. Use hexagon
head bolts or hexagon sooket head bolts, for instanoe,
whioh oan be tightened up seourely using a tool and
whioh are made of a material and with a finish that will
withstand outdoor use.
■ How to install
• Attaoh one end of the anti-fall wire to the mounting hole,
and seoure the other end to the mounting base or other
sturdy plaoe.
The diameter of the hole where the anti-fall wire is
attaohed is 6.5 mm. Attaoh the wire using the anti-fall
wire mounting bolts with a 6 mm diameter and a length of
16 mm, flat washers, spring washers and nuts.
Ensure that the anti-fall wire is strong enough to bear the
weight of the entire pan/tilt head (head, housing, oamera
and oable).
• Be absolutely sure to use parts suoh as flat washers or
spring washers together with the bolts to prevent the bolts
from ooming loose.
<Dimensions of area where unit is mounted>
The diameter of the four pan/tilt
5(E)