Panasonic CF-28 - Manual (Page 15)

(Wind.Qw.s. BET)
Input your password
Wait for 10 seconds after confirming that the hard disk access has been completed, and
input the user name and password, then select [OK], Until the correct user name and
password are entered, the computer will not operate.
SGiect User (only necessary when multiple accounts are created)
Wait for 10 seconds after confirming that the hard disk access has been completed, then
select the user.
Select your application
You are able to start working on your computer.
X note >
The power saving function is factory set, so if there is no input from a key, the touch
pad, the touchscreen (only for models with touchscreen) or an external mouse (when
one is connected) for a certain interval of time, the power to the LCD and hard disk may
be turned off. The LCD will resume operation when the touch pad, the touchscreen
(only for models with touchscreen) or an external mouse (when one is connected) is
used or a key is pressed.
The power to the LCD may be turned off while Windows is setting up or even when an
application software is being installed. In this case, because it is conceivable that a
selection dialog box will be shown, do not press ( Space ] or ( Enter ) to attempt to
resume from this condition as doing so may trigger a selection, but instead, press a key
unrelated to the direct triggering of a selection, likeC CtrO .
In addition, when the computer is left alone, it automatically enters the standby or
hibernation mode ((^^^ “Standby/Hibemation Functions”). The computer will
resume by rotating the power switch.
When a new device has been installed or a new Windows Component has been added in
[Start] - [Settings] - [Control Panel] - [Add/Remove Programs], [Insert Disk] may ap­
pear. Select [OK] and then specify [c:\winnt\cdimage] in place of [c:\sysprep\i386] or
[A:], then select [OK].
e.g., [c:\winnt\cdimage\i386] in place of [A:\i386]
When you create the first new account, you can only select a Computer Administrator
account.
Only the added user account will be displayed in the Welcome screen. The
Administrator’s account created during Windows setup (when the computer is started
up for the first time) will not be displayed.
When switching to a different user with the Fast User Switching function, it may not be
possible to set the settings of the display. In this case, log on with the administrator
authority again, not using the Fast User Switching function, and try the operation once
more.
15