Panasonic CF-28 - Manual (Page 3)

Read Me First
For U.S.A.
Federal Communications Commission Radio
Frequency Interference Statement
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference wilt not occur in a particular
installation, if this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the Panasonic Service Center or an experienced ra-
dio/TV technician for help.
Warning
To assure continued compliance, use only shielded interface
cables when connecting to a computer or peripheral. Also, any
changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Responsible Party: Matsushita Electric Corporation of America
One Panasonic Way
Secaucus, NJ 07094
Tel No:l-800-LAPTOP-5 (1-800-527-8675)
FCC Regulation Notice for modem
This equipment contains a FCC approved modem.
Manufacturer of modem: Aztech Labs, Inc.
Model No. MP3930V-W{C)
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
1. This equipment complies with Part 68 of the FCC rules. On
the computer is a label that contains, among other informa­
tion, the FCC registration number and ringer equivalence
number (REN) for this equipment. If required, this informa­
tion must be provided to the telephone company.
2. An FCC compliant telephone cord and modular plug is pro­
vided with this equipment. This equipment is designed to be
connected to the telephone network or premises wiring us­
ing a compatible modular jack which is Part 68 compliant.
See Installation Instructions for details.
3. The REN is used to determine the quantity of devices which
may be connected to the telephone line. Excessive RENs on
the telephone line may result in the devices not ringing in re­
sponse to an incoming call. In most, but not all area, the sum
of RENs should not exceed five (5.0). To be certain of the
number of devices that may be connected to a line, as deter­
mined by the total RENs, contact the local telephone com­
pany.
4. If your telephone equipment cause harm to the telephone net­
work, the telephone company will notify you in advice that
temporary discontinuance of service may be required. But if
advice notice isn’t practical, the telephone company will no­
tify the customer as soon as possible. Also, you will be ad­
vised of your right to file a complaint with the FCC if you
believe it is necessary.
5. The telephone company may take changes in it’s facilities,
equipment, operations or procedures that could affect the op­
eration of the equipment. If this happens the telephone com­
pany will provide advance notice in order for you to make
necessary modifications to maintain uninterrupted service.
6. If trouble is experienced with this equipment, for repair or war­
ranty information, please contact Matsushita Electric
Corporation of America at DIAL TOLL FREE 1-800-LAPTOP5
(1-800-527-8675). If the equipment is causing harm to the tele­
phone network, the telephone company may request that you
disconnect the equipment until the problem is resolved.
7. There are no user serviceable parts contained in this equip­
ment.
8. This equipment may not be used on coin ser\ice provided by
the telephone company. Connection to party lines is subject
to state tariffs.
9. The Telephone Consumer Protection Act of 1991 makes it
unlawful for any person to use a computer or other electronic
device Jp send any message via a telephone fax machine un­
less such message clearly contains in a margin at the top or
bottom of each transmitted page or on the first page of the
transmission, the date and time it is sent and an identification
of the business or other entry, or other individual sending the
message and the telephone number of the sending machine or
such business, other entity, or individual. In order to program
this information into your fax software, you should refer to
the manual of the Fax software being used.
10. According to the FCC’s electrical safety advisory, we recom­
mend that you may install an AC surge arrestor in the AC outlet
to which this equipment is connected. Telephone companies re­
port that electrical surges, typically lightning transients, are very
destructive to customer terminal equipment connected to AC
power sources and that this is a major nationwide problem.
“Caution; To reduce the risk of fire, use only No.26 AWG or larger telecommu­
nication line cord."
“ATTENTION; Pour réduire le risque d’incendie, utiliser uniquement des
conducteurs de télécommunications 26 AWG ou de section supérieure."
Notice for the products using LCD
This product uses one or more fiuorescent lamps containing a
small amount of mercury. It also contains lead in some compo­
nents. Disposal of these materials may be regulated in your com­
munity due to environmental considerations. For disposal or re­
cycling information please contact your local authorities, or the
Electronics Industries Alliance: <http:/Avww.eiae.org/>