Clarion Platinum Sound Processor - Manual (Page 8)

Platinum Sound Processor 3
1. Battery Charge Status
When the Processor program switch is turned from the off (o)
position to positions
!, !!, or , the red LED light will blink as
follows:
! Up to 4 quick blinks indicate that the battery is fully charged.
! 2 to 3 quick blinks indicate that the battery is sufficiently charged
to power the system.
! 1 quick blink indicates that the battery charge is nearly depleted.
To check the battery charge status while the Processor is in
operation, turn the Processor off and then back on to any program
position. The red LED light sequence will indicate the battery
charge status.
2. Lock Status
When the Processor program switch is turned from the off (o)
position to positions
!, !!, or , and the battery charge sequence is
complete, the red LED indicator begins to flash approximately once
per second to indicate lock status. Flashing will continue until the
headpiece is properly positioned on the head. Once the headpiece is
transmitting to the implant, the flashing will stop, signifying that the
system is sending information correctly.
3. Microphone/System Status
When the battery and lock sequences are complete, microphone and
system status can be verified. The green LED indicator will flicker
in response to loud sounds presented near the microphone, verifying
that the microphone is receiving sound, data is being transmitted to
the implant and the Processor is receiving information back from the
implant. Increasing the sensitivity will cause the green LED to flash
in response to softer sounds, while decreasing the sensitivity will
require more intense sounds for the LED to react. The green light is
not expected to illuminate continuously during everyday use,
especially if the user is in a quiet environment.
Audible Alarm
!
!!
!!
!