Yamaha pw80 - Manual (Page 44)

FRONT WHEEL
Removal
1. Elevate the front wheel by placing a
suitable stand under the engine.
2. Remove the brake cable: Loosen all ca­
ble adjuster screws and remove cable
from handle lever holder. Then remove
cable from cam lever at front brake shoe
plate.
3. Remove the axle nut ® and the wash­
er®.
4. Turn and pull out the front wheel axle; the
wheel assembly can now be removed.
Installation
When installing front wheel, reverse the
removal procedure taking the following steps:
1. Check for proper engagement of the boss
on the outer fork tube with the locating
slot on the brake shoe plate.
2. Tighten the axle nut.
Axle nut torque:
35 Nm (3.5 m -kg, 25 ft lb)
REAR WHEEL
Removal
1. Elevate the rear wheel by placing a
suitable stand under the engine.
2. Remove the tension bar and the brake rod
from the brake shoe plate. The tension bar
can be removed by removing the cotter
pin and nut from the tension bar bolt. The
brake rod can be removed by removing
the adjuster.
Disconnect the drive chain.
Loosen the lock nuts and chain slack
adjusting nuts on both sides.
Remove the axle nut and washer.
3.
4.
5.
1. Adjuster
2. Brake rod
3. Tension bar
4. Lock nut
5. Adjusting nut
6. Axle nut
Washer
6. The rear wheel assembly can be removed
from the machine by pulling the wheel
axle.
Installation
The rear wheel can be installed by reversing
the removal procedure. Take the following
steps.
1. When connecting the chain, make certain
closed end of master link clip is facing
direction of rotation.
2. Be sure to adjust the chain slack. (Refer
to "Drive chain slack adjustment".)
-32-