K'7a(7)|3i^j#lt/mounting the bass drum – Yamaha CBF-32B/36B User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
* § 3 5 : # # 2 A i i ( ± T ' ,
■ o T < t z $
Assembly should be performed by at least 2 persons on a flat surface.
2
. /'^
7
.
K'7A(7)|3i^j#lt/Mounting the Bass Drum
1.
K^-7.CD^§ligBlc;V7. K^AQlUgiS^^ti^-r« (HA#Sg)
h^iZ
r.
msm^)
2.
h-^Utsti'DiiStofiliS-r«
•X-ilSiifSiCIEgiJft'SOS-ro
K, ifSIJAA-A/n^rf'h-^ty KlrTo (CB-
832B/836B/840B)
1. Place the Pivot Mount attached to the bass drum onto the pivot holder located on the Stand
Base. (Refer to diagram A.) Close the holder clamp and loosely fasten with the wing nut. (Refer
to Diagram B.)
2. Adjust the angle of the bass drum's playing surface and then firmly tighten both wing nuts on
the holder.
•X’There is a difference between the drum's playing surface and its resonate surface. The
'Legacy'head is for playing and the smooth white head is a resonator. (CB832B/836B/840B)
Diagram A
HB
Diagram B
Wing Nut
©Tighten
02T«
Close
™omt
Pivot Holder
rONjtCUr < /cifl'o
^Before mounting the bass drum on the stand,
make sure the caster brakes set “ON”.
77$'-tf-t':TICB§T-533F=%ièfctÌ$fe
i-h VA «*)
TEL 053-460-2412