Connections, Connecting an analog audio component, Note – Yamaha DTR2 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONNECTIONS
Connecting an analog audio component
•
Be sure to disconnect the power cords of both
components from the AC outlet before connecting.
•
The same channels of this unit and the other
component should be connected properly; right to
right, and left to left.
1
Connect the ANALOG INPUT jacks (balanced type or
unbalanced type) of this unit to the analog output jacks
of the amplifier or stereo mixer, etc.
2
Connect the ANALOG OUTPUT jacks (balanced type or
unbalanced type) of this unit to the analog input jacks
of the amplifier or stereo mixer, etc.
3
Set the ANALOG INPUT selector. When using the
balanced type terminals, set this selector to the XLR
position. When using the unbalanced type jacks, set
this selector to the PIN position.
NOTE:
Make sure all connections are securely made. Loose
connections may cause intermittent sound or noise.
10