Yamaha DTR2 - Manual (Page 24)

To program desired tunes (APMS=Automatic Programmable Music Selector)
You can program desired tunes in any desired order.
• if the tunes are not numbered properiy, the desired tunes may not be programmed, or program piayback may stop
1 Load the tape.
2 Press the PROGRAM button.
The ARMS indicator iights.
3 Using the digit buttons (1-0, +10, +20), enter the
desired tune numbers in the desired order.
Exampie:
Toseiecttune 12:
Press "+10" and "2".
To seiect tune 20:
Press "+20“ and "0".
To select tune 54:
Press "+20" twice, "+10" and “4".
The dispiay shows the program number (piayback
order) and the programmed tune number.
4 Press the PLAY button (►).
The programmed tunes are played in the programmed
order.
To skip to the beginning of a tune in the program:
Press the FF (►►) or REW (◄◄) button to skip to the
beginning of previous/subsequent programmed tunes.
To check the program contents
in stop mode, press the CALL button.
The programmed tunes are dispiayed in programmed
order.
• When the CALL button is pressed during program
playback, the next programmed tune number to be
played is displayed for about one second.
To erase a programmed tune
Press the STOP button {■), then the CLEAR button.
Each time the CLEAR button is pressed, one programmed
tune wiil be erased beginning with the last programmed
tune.
To clear the whole program
Press the PROGRAM button in stop mode. Aiso, pressing
the OPEN/CLOSE button or turning off the power clears the
whole program.
24