Yamaha YPDR601 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

4 • Remote controller (RC601) - Front panel

iii)

If the copy protect flag is not set on the source, and the rear panel COPY

GUARD switch is set to OFF, the copy-protect flag will not be written to

disc, and the indicator will not light.

The ALARM indicator lights if an error condition occurs. Press the Tr INC and

DISPLAY keys simultaneously to determine the error (see "Errors" on page 30

for details).

(2) Display

This LED display indicates the track and index number of the current disc, as

well as the time in minutes and seconds. The TRACK display is also used to

show error codes. When a disc is loaded, the disc's format (recording method)

is shown. The function of the time display (minutes and seconds) can be

changed using the DIS P LAY key. The selected function is shown on the Display

function indicators (3).

(3) Display function indicators

These indicators show which function is currently displayed by the "minutes"

and "seconds" display LEDs (2).

When A-TIME is lit, the absolute time of the current position on the disc is dis­

played.

When P-TIME is lit, the time of the currently selected track ("Program") is dis­

played.

REMAIN shows the amount of time available for recording on the disc, or when

playing back, the amount of recorded material which remains.

When TOC is lit, then the time of the start of the track is displayed.

(4) INDEX keys

When the disc is in PLAY mode, these keys can be used to position the head at

an index marker within a track, so that replay will start from that point.

(D

DISPLAY

Repeated presses of this key will cycle the display (2) through the four display

modes as shown by the display function indicators (3).

(D

une

This key enables or disables the signal output from the main unit ANALOG OUT

and DIGITAL AES/EBU connectors. When output is enabled, the indicator will

light. The source of this signal is determined by INPUT/REPRO (7).

If the internal lock to the PLL is lost, the LINE key will continue to light, but the

output (analog and digital) will be lost. In the case of an AES/EBU input, the AES/

EBU signal will appear at the DIGITAL AES/EBU (OUT) (7) output, but the

ALARM indicator will be lit.

(7) INPUT/REPRO

When the output is enabled (the LINE key is on), this key enables the selection

of monitoring between the input source (the green indicator will light) or off-disc

REPRO (the red indicator will light). Switching to the appropriate monitor

source is done automatically by the YPDR when possible (eg pressing P LAY will

switch to REPRO if this has not already been selected).

(D Meters

These 24-segment bargraph meters indicate the level of the signal currently be­

ing monitored. Care should be taken to avoid lighting the top OVER segment,

YPDR

Remote controller (RC601) - 13

Advertising
This manual is related to the following products: