Yamaha YPDR601 - Manual (Page 18)

4 • Remote controller (RC601) - Front panel
as this indicates digital clipping. A PEAK HOLD function for these meters is
available through a rear panel switch. Note that this peak hold function is not a
"permanent" peak hold - the peak segments of the meters "drop back" after a
few seconds.
(9) Transport controls
The bottom row of these controls are similar to the transport controls on a tape
recorder. STOP and PAUSE work in the same way as they do for a tape record­
er. PLAY starts disc playback, and REC and PLAY together start the recording of
audio data. However, for data to be recorded (either audio or TOC), the STDB Y
key must first be pressed in order to position the laser.
The top row of transport keys provide additional functions. The REC MUTE
mutes the input signal to the recorder. The AUTO PAUSE key is used in the TOC
PRE mode to complete recording of the pre-defined track (this key has no func­
tion in the TOC AFTER mode). The TOC key is used with the RECORD key to
record TOC information in either the TOC PRE or TOC AFTER modes, and the
Tr INC and IXINC are used to write track and index information respectively,
in real time. In TOC PRE mode, the Tr I NC key has no function, as track infor­
mation is pre-written.
(0) TRACK keys
These keys are used when the disc is stopped or playing, and allow setting of a
track, to play the disc from the selected track.
@
SEARCH
These keys may be used when the disc is paused or playing. They allow search­
ing for a particular point on the disc within a track by ear, rather than by index
position (similar to CUE and REVIEW on a tape recorder).
(g) REHEARSAL
The rehearsal mode tests the cue point of the source machine. Press this key
(which will light) to go into and out of rehearsal mode. When in rehearsal mode,
pressing PLAY and REC simultaneously will start the YPDR in rehearsal mode,
which will stop automatically after 10 seconds.
The appropriate "PLAY" and "STOP" commands are transmitted from the RE­
MOTE connector (16) and Parallel I/O connector (18) to the source machine,
allowing monitoring of the record start point.
YPDR
Remote controller (RC601) - 14