Yamaha YPDR601 - Manual (Page 22)

5 • Connection - Single-recorder connection
• Set the DRIVE ID switch on the main unit to "0".
• Connect the CONTROL connector of the controller to the I/O IN of the
main unit.
• Connect the terminator block to the I/O OUT of the main unit.
• Connect the audio source. When an analog source is used, the controller
INPUT SELECT ANALOG/DIGITAL switch should be set to ANALOG (the
position of the other switch has no effect).
• When an AES/EBU digital source is used, connect the XLR AES/EBU IN to
the source. Make sure the controller INPUT SELECT switches are set to
DIGITAL and AES/EBU.
• When an SDIF-II source is used, connect the source to the two BNC D.IN
connectors. Make sure that the controller INPUT SELECT switches are set
to DIGITAL and D.IN
• If SDIF-II is to be used as the input format, SYNC (word clock) connections
should be made. The YPDR can be used as a word clock master or slave.
• If the YPDR is to be used as a master, connect the YPDR SYNC OUT to
the word clock input of the source. Set the controller EXT W.SYNC DIP
switch to OFF, and set the source to receive external word clock informa­
tion.
• If the YPDR is to be used as a word clock slave, connect the SYNC IN of
the YPDR to the word clock output of the source device. Set the controller
EXT W.SYNC DIP switch to ON, and set the source to transmit word clock
information.
• Connect the YPDR main unit ANALOG OUT connectors or AES/EBU con­
nector to the monitoring system.
• If the YPDR is to be used for the remote control of a source machine such
as the DMR8, connect a 9-way remote cable between the REMOTE of the
main unit and the REMOTE of the control slave.
• If 2-way parallel communication is to be used, connect the D-sub 15-pin
PARALLEL I/O to the other device.
• Connect the power cords.
5.2.1 Analog input level adjustment
• Set the level of the source output to the nominal level.
• Set the master fader of the console (if used) to the nominal level.
• Set the HIGH/LOW switch on the rear of the main unit to the appropriate
position (HIGH=+4dB, LOW=-9dB, both nominal levels).
• Play the source through the YPDR system, making sure that the LINE key
on the controller is on, and the INPUT/REPRO key is set to INPUT.
• Adjust the ±3dB trimmer controls on the rear of the main unit so that the
loudest sections of the program material go to the "0" segment, but do not
light the OVER segment of the controller meters.
• If, after adjusting the trimmers to add 3dB of attenuation, the "OVER" seg­
ment still lights, it may be necessary to "back off" the source output level
by a few dB.
YPDR
Connection -18