Using the aux send/return loop – Yamaha MT120S User Manual

Page 24

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

USING THE AUX SEND/RETURN LOOP

The MT120S’s AUX SEND controls function like a secondary mixer that derives its input signals from the main mixer’s four

channels and combines them into a mono signal which is delivered via the AUX SEND jack (refer to the diagram below). You
can use the AUX SEND controls to create an “effect mix”, independent of the main mix, thus adding the required degree of
effect to each channel signal. The AUX SEND signal is sent to the input of an external signal processor (reverb, echo or
other effect device), and the output from the signal processor is returned to the AUX RETURN jacks. The level of the signal
received at the AUX RETURN jacks can be adjusted using the AUX RETURN control, and the resulting signal is combined
with the MT120S’s main stereo output signal.
Since the returned effect signal is combined with the mixer's stereo output signal, the AUX SEND/RETURN loop can be

used in mixdown to add an effect to tracks when they are being recorded. In this case tracks must be assigned to tape using
the “panned channei-to-track” assignment method (see page 13).

[Note] Since the AUX SEND/RETURN loop returns the

effect signal to the mixer section’s stereo outputs,
effects can be added to channels during ping-

pong recording as long as the panned channel-to-

track assignment method is used. The AUX SEND/

RETURN loop cannot be used to add effects when
recording tracks which have been assigned using

the direct channel-to-track assignment method.

22

M T 1 2 0 S M U L T I T R A C K C A S S E T T E R E C O R D E R

Advertising