Panasonic PV C2020 - Manual (Page 19)

VCR Plus+ System Programming
1
Process of Recording
Connect!^ olSetu^ol
Display PROGRAM
screen.
Press PROGA/CR+.
2
SET pnOGRAM
V€R Plus+ PROGFWMMiNG
TIWER PROGRAMMING
ON TIMER
SELECT:A ▼ KEY
SET
END ► KEY
PFOG KEY
Select VCR Plus+ PROGRAM.
1) Press AW to
select.
2) Press ► to
display.
3
VCR PIUS+ SYSTEM
ENTER PLUSCODE NUMBER
USING 0-9 KEYS
Enter PlusCode
programming number.
1) Press
NUMBERED
keys.
2) Press
PROGA/CR+
^ when finished.
To Make Corrections
Press repeatedly to delete the PlusCode programming number.
END :PflOG KEY
4 VCR PIUS+ SYSTEM
ONCE
DA ( LY (MON-FR I)
WEEKLY
SELECT :A Y KEY
SET ;► KEY
END ;PROG KEY
Set Record Frequency.
1) Press
AT
to
select.
2) Press ► to set.
5
28TUE12:00P12:3OP 69
\i/
CATEGORY:N/A
--------------- /HAc-
SELECT CATEGORY
PBS
SP
SELECT;A ▼ KEY
SET
► KEY
END :PROG/ACTION KEY
Set Category and
Record speed.
• If wanted, make a note (see page 14.)
1) Press
AT
to
select.
2) Press ► to set.
Select desired type:
• Categories -> N/A (not applicable), SPORTS, MOVIE, COMEDY
MUSIC, or DRAMA
• Speed -> SP, LP, or SLP
To Make Corrections
Press ◄ ► to move the cursor and AT to make the correction.
6 P DT START STOP CH SPD
1 28 I2:00p 12:30p 69 SP
CANCEL;ADD/DLT KEY
SELECT 1-8:
a ▼ KEY
ENTER :► KEY
END :PROG/ACTION KEY
End programming.
Press
PROG/VCR+
(or ACTION.)
Exit this mode.
Press PROGA/CR+
(or ACTION) twice.
• PROG TIMER indicator lights on
the unit.
Programming
[^^Check list before you begin.
EJ The clock is set to correct time.
O VCR Plus+ System Setup is complete.
(See pages 17, 18.)
Use normal Timer Recording steps if:
• a program PlusCode programming
number is not listed.
• program, such as a sporting event, may
run over scheduled stop time.
See page 15 to:
• cancel a timer recording in progress.
• replace program contents.
• review or clear program contents once set.
You can obtain unlisted PlusCode
programming numbers by calling 1-900-
454-7587, Call costs approximately $.95
per minute.
Avoid overlapping program times.
If you’re using a cable box, make sure
that it is turned to the desired channel
and the power is left on for timer
recording.
Timer programs memory capacity is 8.
To add more programs, please first clear
other programs. (See page 15.)
19