Panasonic CF-25 - Manual (Page 32)

Dealing with Probiems
Connecting Peripherals
Your peripheral*does not
work (An error occurs while^
installing the driver)
You need to use drivers conforming to Windows 95 Version 4 00 950B (OSR-2) Some
earlier drivers will no longer work
For more information please ask the manufacturer of the dnver m question
Unable to print i
t 1 ‘
s ^ ^ t \ Vi ,
• Check the computer-printer connection
• Make sure the printer is on
• Make sure the printer is in the online state
• Make sure paper is in the printer tray and there is no paper jam
• Has the Setup Utility been used to set [Parallel Port (Address)l to [Automatic (PnP)]
[378} or [3BC]'^
The,cursor does not move
from mouse'operations
j "'y" *,* ^ ‘ ,
^ (
.! 'V .
• The Coffee break Password may be set check it ||jj§j is displayed If this is the case, input
the Coffee break Password
• Check your mouse connections, then reboot the computer from the keyboard
From the keyboard, you may choose to press down on then select [Shut Down]
The device connected to the
serial port does not work
^ ^ ' f
1. ^
T ^ i, J ^ VI
• Check the connection
• Confirm that the device driver for the serial port works Please refer to the reference
manual for the device
• Confirm that two mouse devices are not connected, one through the ext keyboard/mouse
port and the other through the serial port
• ' Try setting [Internal Pointing Device] to disable in the Setup Utility
• Has the Setup Utility been used to set [Serial Port] to [Automatic (PnP)j or [3F8]^
External mouse or track
ball connectedjo the PS/2
port does not work
In some circumstances if a PS/2 external mouse with a serial interface conversion function
IS connected to the port it may not operate normally Connect it to the serial port
A PG Card does not work
* -■
• Make sure the card is properly inserted
• Confirm that the card conforms to the PC Card Standard
• A dnver for Windows 95 may need to be installed
• Note that after a driver is installed, the computer must be rebooted
• There may be no interrupt request (IRQ) line available Deactivate unnecessary equip­
ment using [Supervisor Setup) in the Setup Utility
There is be no remaining IRQ when you installed an optional CD-ROM Pack and insert
more than two PC Cards or when you set [Sound IRQ-B] in [Supervisor Setup] in the
Setup Utility and insert more than two PC Cards Be sure to deactivate unnecessary
equipment before any PC Card
• Read the PC Card’s manual Or you may need to call the manufacturer of the PC Card
You do not know the - i
^available RAM module
page 24
The RAM module has not
been recognized Make sure the RAM module has been properly inserted
The address map lor IRQ,.
I/O port address, etc. is
unclear Check the address map by going to [View Resouiccs] in [Start] - [Settings] - (Control Panel]
- [System] - [Device Manager] - [Computerj - [Properties]
The [Version ConilictJ < -
appears Select 1 ■ [
Others
You \vish to initinlize the set­
tings of each driver See "i^einstdlling SuHwarc” (C^’pdge 34) Tor i n s t r u L l J o n s on how to make the s e t t i n g s for
each ot the various ret|iiired tlrivcrs
32