Panasonic OMNIVISION PV-DM2791 - Manual (Page 31)

^Important: If a remote control button does not work when pressed, press the vcr button on the remote
and try the button again.
Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few secxinds
to cancel the Timer Recording.
• Any future daily or weekly recordings
will be performed as programmed.
Review, Replace or Clear Program
Contents : (Recording is not in progress)
1
Repeat steps 1 and 2 on page 30.
P DT START STOP CH SPD
2 8 10:OOa12;8(^12S SP
3 10 8:OOp 9:00p 10 SP
4 SU S:00p10:00p Li LP
CANCEL;ADD/DLT
SELECT 1-B: a ▼
ENTER ;SET
END ;PR0G
Press
AT
to select
the desired program.
8 SAT 9:OOP12:OOA 08
To Replace program...
r M e T/
start stop ^
1) Press SET to display.
2) Press
AT
to select
and press SET or
◄ ► to set new
program contents.
3) Press PROG.
eiiiBaiaBEBisEBi
SELECT;A T
SET
:SET
END l PROG
To Clear program...
Press ADD/DLT.
P DT START STOP CH SPD
a-------- :--------: - — —
2 8 10:00p12:00a125 SP
3 10 8:00p 9;00p 10 SP
4 SU 9;0t^10:00p LI LP
SELECT 1-B; a t
ENTER :SET
END ;PROG
Press PROG twice to exit this mode.
455^
• 2 minutes before Timer recording is performed,
“PLEASE PREPARE FOR TIMER REC" appears
and/or the PROG TIMER Indicator flashes.
Be sure a cassette with record tab is loaded and the
unit is in Stop mode.
• If the start times of two programs overlap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up
during a normal recording or One Touch Recording
{page 18), the Timer Recording will not be performed.
• If there is a power interruption of more than one
minute, the recording may not be performed or
continued.
• If “INCOMPLETE" appears after all items have been
set, check all entries and make necessary
corrections.
31