Panasonic KV-SS855D - Manual (Page 28)

Others
IScanning copying paper (such as carbon or carbonless paper)
When scanning copying paper, select "1 page" by the hopper key. (See page 9.)
Because it cannot be scanned using continuous mode.
When setting the copying paper on the hopper, lift the paper feed roller module (see
page 33) slightly and set the copying paper accurately. Then put the paper feed roller
module down on the copying paper.
Copying paper scanning can be performed from a personal computer according to the set­
ting on the PC.
iHow to select the paper path for scanned document
To select the front, set the pointer lever
to the lower side.
To select the straight path pass
through to the back, set the pointer
lever to the upper side.
'Pointer lever
The pointer lever is located on the back side
of the scanner.
iWhen multiple-sheet feeding occurs
When multiple-sheet feeding occurs, ad­
just the ADF selector.
• The factory pre-set is "4".
• If the paper is thin, set to "5". If the
document continues to multiple feed,
increase the selector level by one un­
til the problem is corrected.
• When the top side of a thin document is
damaged (torn, creased, etc.), set to "3"
and the document will insert easier.
The amount of overlap for the separator
and retard rollers is as follows.
ADF selector Overlap
1 0 mm
2 0.1 mm
3 0.2 mm
4 0.3 mm
5 0.4 mm
6 0.5 mm
7 0.6 mm
28
If the paper is thick, set to "3". If the
document continues to multiple feed,
increase the selector level by one un­
til the problem is corrected.
ADF selector
The ADF selector is located on
the left side of the scanner.