Panasonic RN-102 User Manual
Panasonic, Location of controls, Power source
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Location of Controls
Before connecting, operating or adjusting this product,
please read these instructions completely.
The shape of RN*102's
cover is different
from this figure.
Tape COUNTER and
'SLEЯONE Selector (RN-122)
DC IN Jack
UM-3, R6/LR6 batteries
or equivarent (not included)
•Batteries installed with incorrect polarities may leak and damage
•Do not mix batteries (old and new) or types (carbon and alkaline).
•When the batteries are weak, the tape speed will slow down, the
sound will become distorted, and the volume will decrease.
•if the set is not used for a long period of time or is used only from an
AC power source, remove all the batteries to prevent potential
damage due to possible battery leakage.
•For AC power operation, use only Panasonic AC adaptor
Press the © side toward the © battery terminal and lift up.
Removing the tab(s) of the cassette (with a small screwdriver) will
prevent accidentai erasure.
To record again, cover the hole of the tab with adhesive tape.
Get into habit of cleaning the head assembly (after every 10 hours or
so) with a cotton swab dampened with a little alcohol.
AC; 240 V, 50 Hz (with optional
Panasonic AC adaptor
Battery; 3 V (two UM-3, R6/LR6,
1.2 cm/s, 2,4 cm/s
2 hours with RT-60MC microcassette
»nnn /at “1 O”
2-track monaural recording and playback
DC IN; 3V
135 g (RN-102), 138 g (RN-122) without