Assemble intercom, Programming intercom, Step 1 – Chamberlain NLS1C User Manual
Page 2: Step 2, Create new network, Add to an existing network, Install 4 aa alkaline batteries (not provided)
2
Assemble Intercom
Step 1
Install 4 AA Alkaline batteries (not provided).
Step 2
Adhere rubber pads to bottom. Repeat Steps 1 and 2
for any additional intercoms.
Programming Intercom
The intercom must be programmed to at least one
other intercom to become a network or it can be
programmed into an existing network.
Create New Network
Before programming, clear memory on all intercoms.
Press the Learn button on the new intercom until a
beep is heard. Within 10 seconds put the second
intercom into Learn Mode (refer to the following table).
Each intercom will emit a tone when entering
programming mode. It may take up to 3-1/2 minutes
for a secure network to be established. Repeat for any
additional intercoms.
Add to an Existing Network
Press the Learn button on the new intercom until a
beep is heard. Within 10 seconds put any networked
intercom into Learn Mode (refer to table below).
Each intercom will emit a tone when entering
Programming Mode. It may take up to 3-1/2 minutes
for a secure network to be established. Repeat for any
additional intercoms.
NOTE: Do not program new intercoms to each other
before adding them to the network or they will form
a separate network and the memory will need to be
cleared.
Press and release the Talk button to verify network is
complete.
MONITO
R
HOL
D
OFF
1
3
2
4
VOLUME
T A
LK
ACTIVE
MONITO
R
HOLD
OFF
1
3
2
4
VOLUME
T A
LK
ACTIVE
VOLUM
E
MONIT
OR
CHANNE
L
HOLD
OFF
ACTIVE
TALK
1
3
2
4
INTERCOM
LEARN MODE
Press the Learn button
until a beep is heard.
OR
HOLD
ACTIVE
TALK
1
3
2
4
VOLUME
MONITOR
CHANNEL
OFF
INTERCOM
LEARN MODE
Press the Learn button
until a beep is heard.
OR
HOLD
ACTIVE
TALK
1
3
2
4
VOLUME
MONITOR
CHANNEL
OFF